Ask Experts Questions for FREE Help !
Ask
    jgee's Avatar
    jgee Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 5, 2009, 11:53 PM
    The flame on the water heater only burns for a few seconds and then shuts down.
    I am not currently getting any hot water out of my water heater. The flame comes on and burns for a few seconds and then shuts off. This same patterns then continues to repeat.

Check out some similar questions!

Brand new water heater: Starts hot, then water gets cold after few seconds [ 9 Answers ]

We just moved into a brand new condo which has its own water heater. We went to take a shower this morning and the first few seconds of the shower were very hot, then it went cold after 10 seconds. We tried again after half an hour, same thing. There was enough hot water for my husband to shave but...

Blue Flame-Pilot will not stay lit-Hot Water Heater [ 7 Answers ]

My pilot light has a crisp blue flame when I light it and stays that color, but it will not stay lit. I have no problem lighting it, and then it takes off, but then it will go out after an hour or so. So, is this the thermocoupler?

Excessive Flame from Hot Water Heater Pilot Light [ 2 Answers ]

Recently replaced thermocouple in hot water heater due to no pilot light. Upon installation, the pilot light burns with a much higher flame than before. What might cause this?

Water heater shuts off [ 2 Answers ]

I have a state select water heater that the igniter shuts off and takes a while to start back up is there a special way to get it started?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.