 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
I have a Payne 394GAW that starts and burns for 3 seconds, shuts down and recycles.
I have a Payne 394GAW (about 1987, no standing flame,electric ignition). Starts fine and burns 3 to 4 secs and recycles. Classic dirty flame sensor problem. I cannot find a flame sensor to clean. I have removed burners and looked throughout. Is it in the ignition assembly? Is there some other flame sensing device? What else could be the problem? The pilot and gas seem to work fine. Thanks
|
||||
Check out some similar questions!
My payne heat pump comes on and works for 3 seconds and shuts off
I am not currently getting any hot water out of my water heater. The flame comes on and burns for a few seconds and then shuts off. This same patterns then continues to repeat.
Lennox heat and air furnace is showing default saying ignition lockout due to recycles what does that mean
We start our central heater and the furnace kicks in and then the blower starts and the house warms up but when it reaches the desired temperature. When the temp. drops and you can hear the furnace start but the blower will never kick in. If we shut off the whole thing and wait about 1 hour, we...
I just moved into a new home and noticed that each time the A/C comes on it starts up for about 3 seconds, shuts off, then starts up again. This second start-up is when it stays on until the desired temperature is reached. I have a Honeywell SuperStat thermostat that is about four years old and...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
