 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Let me Google that for you.
This took about three seconds to find. Click on the first hit on the Google page. Then click on Downloads. Then click on Owners Manuals Then click on 1557.pdf OR... just click on the second hit on that Google page. It is direct to the manual. Without a blower no voltage is required. With a blower 120v is required. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Bryant Plus 80 furnace. Sometimes the HSI glows red before the gas turns on and sometimes it does not. One time I actually saw the HSI glow red then stop glowing red and start glowing red again within a matter of seconds 2-3 seconds at most. Does this mean I have a voltage problem in the...
I have a Lennox G20Q3E-75-1 furnace. The ignitor lights the pilot light but not the burner. The ignitor never shuts off. The fan blower will come on after about a minute or so but the burner never lignts. Any ideas??
I recently turned on my heater for the first time. The fan is blowing, but there is not hot air. I went into the attic and reset the ignitor switch and still no luck. The green light in front of the furnace is blinking ten times, indicating the line voltage polarity is reversed. What should my...
I was checking voltage at the gas valve on a coleman furnace and my reading was 18 volts. What would cause the drop in voltage? I do have 24v into the board.
If I use a diode bridge across a single phase a.c. supply to produce 12 Vdc, what should the rms voltage of the a.c. supply be
View more questions Search
|
