Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Bryant Furnace Secondary Voltage/Blown 3 amp fuse.
[ 30 Answers ]
Hi all! I've been reading the posts regarding fuses blowing in the secondary voltage circuits on Bryant furnace/blowers. I blew the 3 amp fuse in this circuit two weeks ago on my gas Bryant furnace. Repairman diagnosed the problem using the flashing led light (2 fast, 4 slow). He replaced the...
Track lights: low voltage vs line voltage.comsume the same electricity in the end?
[ 11 Answers ]
Hi! I just installed a section of track light in my living room just to see what it would look like and so far I'm not convinced... you see, I had a regular celing lamp with a 75w incandescent bulb and the room was very well lit... now with the track light I find that I need 3 fixtures with halogen...
Furnace/AC/fan won't run. No voltage to thermostat
[ 1 Answers ]
I don't have any voltage to the thermostat. There is power to the control board. What do I check next?
Crazy voltage at 2 stage gas valve
[ 13 Answers ]
I have a 3 month old 2 stage goodman gas furnace that is making a clicking sound at the gas valve. What happens is when the themastat calls for heat the draft motor turns on and that's when the clicking sound begins at the gas valve. I took a voltage reading at the gas valve during this clicking...
Trane XL80 No Voltage to Gas Valve
[ 2 Answers ]
TRANE XL80 Propane Furnace not working I have an older TRANE XL80 (1989) recently quit working. I discovered the ignitor was not glowing and traced it to a bad relay in the control module. I had the relay replaced, now the ignitor will come on and the unit fires up but will only burn for about 10... View more questions Search
|