Ask Experts Questions for FREE Help !
Ask
    JohnofVA's Avatar
    JohnofVA Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 27, 2010, 12:17 PM
    Bryant plus 90 code 31?
    Having a similar problem. Just started this heating season. After several times of "fixing" it without really knowing what I did, the last time I happened to bump the pressure switch while it was running and the burners went out (I am thinking the pressure switch has to stay activated while unit is running burners, is that a daaaaa?) I decided to pull the connectors at the pressure switch a couple of times (I've seen service techs do that during their $300 seasonal checkups) and so far the unit is cycling OK.

    Can someone tell me what the Conversion Kit 325878-751 mentioned in this set of answers is and where to get one?

Check out some similar questions!

Bryant Plus 80 Code 33 [ 10 Answers ]

I have a Bryant Plus 80 that is throwing a error of 33 (limit or flame roll out switch is open). The last time this happened was because the hot surface igniter was broken (frequent problem as my furnace has a tendency to short-cycle). I had picked up a couple extra ones so I had them on hand to...

Bryant code 33 [ 0 Answers ]

Hi, I really hope someone can help me. I have a Bryant 340MAV. I cannot seem to get the furnace to stop flashing code 33. It doesn't go to 13 either, which I find strange. I also tried bypassing the limit switch, temporarily, just to see if this was the problem. Still getting 33. Also...

Bryant code 42 [ 1 Answers ]

When the furnace is given the self test all appear to run fine the inducer hi and low, blower high and low and igniter glows. Furnace shuts down after about 2 min on high output. Could it be the control board?

Bryant code 33 [ 1 Answers ]

Bryant gas funace model 310aav042090aaja. Code 33. Wired around limit and it worked fine. Replaced with new limit throws code again. Vents clear. Filter clear. What next? Is it really getting too hot? Runs about 4 minutes before throwing code and cycles down about 3 minutes.

Bryant plus 90 code 43 [ 0 Answers ]

I have a Bryant Plus 90 series. I'm getting a code 43. From what I gather in my search, does it have anything to do with the blower motor?

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.