 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Wiring for a Janitrol HPT18-60 to a LUX TX9100E
I had a Janitrol HPT18-60 thermostat that I have replaced with the LUX TX9100E programmable thermostat and just want to make sure I have it wired correctly. I have a heat pump with emergency heat, the LUX does support 2 stage heat pumps.
The Janitrol was wired as follows: Y = Yellow G = Green R = Red O = Orange W = White E = Brown C = Blue I have wired the LUX as follows: A = unused RH jumpered to RC = Red W2 = Brown and White (understood this to be second stage or emergency) G = green Y jumpered to W1 = yellow O = orange B = unused My main question is the Janitrol had a W2 which was white wire and Emergency which was brown wire. The LUX wiring diagrams shows the W2 as the auxiliary so I put both white and brown wire to this. Thanks for any assistance you can provide! C = blue |
||||
Check out some similar questions!
Need a wiring diagram for a JANITROL HPT 18-60 thermastat
I have a white wire going to W2 and E both and a blue wire going to C. Where will these go on the new Honeywell thermostat?
I have a white wire going to W2 and E both and a blue wire going to C. Where will these go on the new Honeywell thermostat? Everything else matches up.
current wiring is Y=Yellow G=Green R=Red O=Orange W2 and E both are connected with the White Wire C= Blue and new t-stat has G
Replacing Janitrol thermostat with LUX programmable Tstat, all wires lined up Y, G, R, O, C except W2 and E when switching from a Janitrol HPT18-60 to a LUX TX9100E. The Janitrol had a W2 white wire and E brown wire, and the new only has W1 and W2. Should the old W2 white actually go to W1 (I...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
