 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Replacing Janitrol HPT18-60 with LUX TX9100E Thermostat
Replacing Janitrol thermostat with LUX programmable Tstat, all wires lined up Y, G, R, O, C except W2 and E when switching from a Janitrol HPT18-60 to a LUX TX9100E.
The Janitrol had a W2 white wire and E brown wire, and the new only has W1 and W2. Should the old W2 white actually go to W1 (I assume it is the main heat pump) and then E to W2 for emergency electric heat? |
||||
Check out some similar questions!
I have an older analog Lennox thermostat and am replacing with a Lux ATX500 thermostat. The Lennox thermostat connections do not match those on the Lux. The Lennox is a 6 wire connection with terminals: F, V, R, X, Y, M The Lux has terminals: G, Y, W, RH, RC The Lux instructions are very...
Please help. I have an old thermostat and know nothing about it but wanted to put the new Lux TX9000TS in for programming my heating and cooling. MY old bryant lr11746 thermo is hooked up with G1, R, O, C, E, W2, and a Y. Is there anybody that could help me figure this out as to what needs to go...
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
My existing thermostat is a Janitrol HPT18-60. Wich has 7 connections, and 6 wires... Y-yellow, G-green, R-tan, O-brown, C-blue, and a red wire connecting an E and W2. I'd like to replace it w/ a Honeywell RTH230B. Wich has... Rh, Rc, W, Y, and G. However, I cannot find a wiring schematic,...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
