Problem with goodman gue060-3 furnace?

debaker Posts: 1, Reputation: 1

New Member

Dec 4, 2010, 10:06 AM

Problem with goodman gue060-3 furnace?

I need part number B13707-23A made by United Technologies HSA electronics. Is this part available?

ma0641 Posts: 15,675, Reputation: 1012

Uber Member

Dec 4, 2010, 02:17 PM

Have you tried a Goodman distributor? Or an Amana?

Add your answer here.

Check out some similar questions!

Goodman Furnace Blower Problem [ 0 Answers ]

I have a builder installed Goodman GDS80904BHA that is approximately 5 years old. Recently, the furnace seems to be shutting down and "recycling" before the call for heat has ended. Here's what's happening: 1. Call for heat. 2. Draft inducer starts. 3. Ignition glow plug starts. 4. Gas valve...

Goodman Gas Furnace Problem [ 0 Answers ]

Help! Have a Goodman Gas Furnace, downflow. It works sporadically (and only for a short time, generally 5 consecutive cycles). 45 out of 50 times the thermostat will trigger it to start, I will hear the motor start up (or what I assume is the draft inducer) and then after a minute will shut off....

Goodman Furnace problem [ 2 Answers ]

I have a Goodman Dependable Nintytwo furnace. The draft inducer motor comes on but the furncae does not light. The motor will run for long periods. It will kick off then kick back on and the furnace will light. The furnace is not consistent, sometime it lights and sometimes it does not. It has...

Goodman furnace problem [ 4 Answers ]

I have two goodman furnaces. They both heat up, but, they both have erratic or uneven sounding flames. They run for a while and then click the flame sensor snap switches off. What would cause this, especially same problem on 2 different units?