 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Hi have been reading the various posts for a couple hours now. When my Goodman GMNT-080-48 forced air starts up, all appears well on start up sequence ; blower runs and igniter heats up and then turns off. Blower never comes on and the heat never seems to get going full. The little red light...
Outdoor temperature under 30degrees our furnace will not kick on. However when "steam" from boiling water or running hot shower fill the furnace area it will kick on. Run until house gets to temp set on thermostat. What could be causing this... Asked few techs' one said a seņor another thermostat....
Home inspector found that the furnace does not have a bracket to hold the furnace filter in place. Is this normal? He is concerned it will be forced into the blower. Goodman furnace GMT070-3B
When it starts up everything appears normal, the induced draft fan starts for about 30 seconds, the glow plug gets red hot, the gas ignites, about 30 seconds later the main blower wheel spins. The hot air comes out of the registers and everything works great but only for about 5 minutes, then for...
Have a 1999 Goodman GMT070-3B Heater and it hasn't been working properly . After the initial start up of the heater the unit will ignite, once the blower engages the flame will go out and the blower will continue to run with no heat. I have replaced the Venter Pressure Switch which seemed to work...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
