 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman Gas Furnace Problem
Help!
Have a Goodman Gas Furnace, downflow. It works sporadically (and only for a short time, generally 5 consecutive cycles). 45 out of 50 times the thermostat will trigger it to start, I will hear the motor start up (or what I assume is the draft inducer) and then after a minute will shut off. After three times it will automatically shut off and quit trying. Sometimes (but rarely)I will hear the draft iducer motor start up and a sound like the gas kicking on, but then it shuts off quickly resulting in the blower forcing out cold air instead of hot. Pulled out the flame sensor but it didn't look corroded to me, maybe just a bit dull looking (as opposed to shiney). Air filter is fine. Squirrel cage has been cleaned to the best of my ability- no dust or debris. Any suggestions? |
||||
Check out some similar questions!
I have a Goodman Dependable Nintytwo furnace. The draft inducer motor comes on but the furncae does not light. The motor will run for long periods. It will kick off then kick back on and the furnace will light. The furnace is not consistent, sometime it lights and sometimes it does not. It has...
When it starts up everything appears normal, the induced draft fan starts for about 30 seconds, the glow plug gets red hot, the gas ignites, about 30 seconds later the main blower wheel spins. The hot air comes out of the registers and everything works great but only for about 5 minutes, then for...
I have two goodman furnaces. They both heat up, but, they both have erratic or uneven sounding flames. They run for a while and then click the flame sensor snap switches off. What would cause this, especially same problem on 2 different units?
I have a Goodman Gas Furnace, the hot surface ignite will not come on nor the flame sensor. I have tried everything and I am fresh out of ideas. Could you please help me on this. Thanks
I have a Goodman 93% efficient furnace that short cycles the gas burners. It cycles the vent on, starts the igniter, fires the burners and kicks on the blower but the burners only stay on for a short time ( less than 30 seconds). The led on the circuit board gives me 3 flashes indicating " pressure...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
