Ask Experts Questions for FREE Help !
Ask
    tgf222's Avatar
    tgf222 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 14, 2010, 01:09 PM
    Cleaning pilot orificee
    Old Carrier. How do I get to the pilot orifice to clean it? It's buried between some sheet metal and the main burners. I can't clean it in place. What do I have to disconnect to get it out of there?

Check out some similar questions!

HOW to obtain cleaning contracts and also how todo marketing for my cleaning business [ 13 Answers ]

Hello I just started my own cleaning business 5months ago with my husband I have one contract so far... its a small restaurant cleaning once a week which is not much... I just basically looked through the phone book and that's how I got it really called a bunch of people and got lucky... What...

Does putting gas hot water heater dial on PILOT put pilot light out? [ 5 Answers ]

My gas hot water heater dial has OFF to the left, PILOT in the middle and ON to the right. If we are going away and want to not have the water heated can we just turn the dial to PILOT and the flame will stay lit but just won't heat the water or does the flame go out completely and then PILOT would...

Furnace, model no. Gdpi075-3, I am getting spark to pilot and pilot lights ,spark con [ 2 Answers ]

Furnace, model no. gdpi075-3, I am getting spark to the pilot, pilot lights, spark continues, but valve does not open for main burner. This is a dual stage gas valve. There is 24 volts at pin 4 on the gas valve, I also measure 0.76 volts at spark control, this wire comes from flame sensor. With all...

Cleaning/replacing carrier bimetal auto pilot [ 1 Answers ]

I have a carrier weathermaker sx probably 20+ years old. I am currently having problems w/ the pilot not lighting (bi-metal auto pilot so I hear) I noticed another forum mentioned it may need cleaning. I have fuel, and juice, the thermostat is sending a signal for heat, the blower kicks on but no...

Pilot light stays on but pilot switch keeps resetting [ 5 Answers ]

I have a baso L62AA-5 pilot switch and it used to keep resetting. I would hold the switch down for a good minute and the gas lights, but after a half an hour or so it would go back to its reset position. The standing pilot light was always on and never a problem. After a few days of manually...

View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.