Ask Experts Questions for FREE Help !
Ask
    marcusdion's Avatar
    marcusdion Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Apr 12, 2010, 08:05 AM
    Furnace, model no. gdpi075-3, I am getting spark to pilot and pilot lights ,spark con
    Furnace, model no. gdpi075-3, I am getting spark to the pilot, pilot lights, spark continues, but valve does not open for main burner. This is a dual stage gas valve. There is 24 volts at pin 4 on the gas valve, I also measure 0.76 volts at spark control, this wire comes from flame sensor. With all wires removed from gas valve on ohms I measure 8.9k from pin 4to 2, and from 2 to 3 I measure 109 ohms. #pin 2 and 1 have a jumper.
    Joshdta's Avatar
    Joshdta Posts: 2,549, Reputation: 45
    Ultra Member
    		  
    #2

    Apr 12, 2010, 08:11 AM

    Sand the flame sensor and try again.
    marcusdion's Avatar
    marcusdion Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Apr 12, 2010, 08:33 AM

    I forgot to say I installed a new circiut board (other was burnt) and replaced flame sensor. I am more concerned about the resistance measurement. Does 8,900 ohms across the pins sound to high? And if there is 24 volts there for the first stage to light the pilot what signal or voltage tells the second stage to come on. Also is there a schematic that would show the voltages in progress
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Pilot lights, furnace does not turn on. [ 1 Answers ]

I have an older furnace that I am trying to squeeze one more winter out before replacing. I came home tonight and the house was cold. Went down to the furnace and pulled the cover off and noticed the pilot was lit but the furnace had not fired on. If I blow on the pilot, the coupling sparks and...

IP Pilot flame does not ignite with new spark generator [ 1 Answers ]

Hello, I have a Carrier gas Furnace, (intermittent pilot) where this type LH33WZ503 of igniter is recommended: Carrier LH33WZ503 Spark Ignitor - eBay (item 120503371417 end time Jan-06-10 09:44:05 PST) eBay The specs say: 24VAC, 8mA. Accidentally, I have ordered this one: Product Group...

Warm air furnace: no pilot light, no ignition spark [ 8 Answers ]

I have an International Comfort fan assisted warm air furnace with an issue: The unit does not heat - burners and pilot do not light. The flame blower runs when heat is commanded from the thermostat. There seems to be no gas as the pilot. There is no pilot light, and no spark when...

Gas furnace has an intermittent pilot, pilot lights, furnace tries to start [ 3 Answers ]

Have a 25 plus year old furnace pilot will start when signal sent furnace tries to start makes noise as it tries over and over but will not start. Thanks

Carrier Furnace pilot lights, nothing else happens.its cold! [ 16 Answers ]

Hi All, First, thanks for the great place to ask for help. I've learned a lot about my furnace after reading many posts online, but I have not been able to solve my problem. Here goes: 1) I have a Carrier 58DH060-CC (Made in the 80's) 2) When starting from scratch, if I turn off the...

View more questions Search