Ask Experts Questions for FREE Help !
Ask
    NascarKim's Avatar
    NascarKim Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Oct 31, 2010, 05:51 PM
    Luxaire furnace 3 error lights
    I have a luxaire high efficiency furnace that is getting the error code for the pressure switch being stuck open. I took the rubber hose off to make sure it didn't have any holes and then used a paperclip to clean out the connection by the fan, but it is still flashing 3 after I reconnected the hose. Is there anything else that I can try to do to fix the situation because it is starting to get cold?
    Maxxwelleee's Avatar
    Maxxwelleee Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Jan 22, 2014, 06:27 AM
    Remove the black plastic container which should have 4 hoses hooked to it and will be held in by two screws. If you will probably find water in it. Drain water, reinstall and this should fix your problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Luxaire furnace troubleshooting [ 1 Answers ]

Luxaire propane furnace.. 4yrs old. Following a power outage... the furnace pre blower comes on fan comes on but no heat. Furnace is flashing 3 flashes . Filter is clean and blower motor seems to work on fan. Any thoughts.. Thanks Greg

Luxaire furnace troubleshooting [ 1 Answers ]

I have a 2334 sg. Foot log home it has 2 3.50 ton units 1 of the units runs twice as much as the other.these are brand new units been in house less than year.Had the heat and air company back out to my house 4 times can't really tell me why they have closed down some vents at units didn't really...

Luxaire Furnace [ 1 Answers ]

Our furnace at our second home runs the fan but no heat comes out. This does not happen all the time. Can be a problem because we are not here all the time

Luxaire furnace [ 1 Answers ]

My furnace cuts in and out far too often and my furnace will cut in and blow nothing but cold air. The red trouble shooting light flashes 8 times meaning "lockout caused by loss of flame" Any ideas why either of these situations happen?:confused: I have put in a new flame sensor as well as a...

View more questions Search