 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
My Carrier 58RAV has and LED code #33 "Limit or Flame Roll Out Switch is Open" Instructions state "Open flame roll-out switch or fuse link, manual reset or replace". Where is this switch located? How do you manually reset it? Thank you
My carrier SS furnace blows the inline @amp fuse to the limit switch and then blows cold air continuosly . Is my low voltage supply faulty or do I have a wire grounding out somewhere.
I have a bad limit switch on carrier weather maker 8000 furnace. Can I replace it with new limit that's rated 200 open and 160 close? Old limit is rated 170 open and 130 close.
I had about the same problem last heating season. One repairman said it needed a new control board and then online I read about the pilot ignitor. I replaced stark electrode and pilot burner and it seemed to fix it. The it started again so since I bought the control board online previous, I put...
I have a York gas furnace that is about 18 years old. The fan is blowing continuously. Tried to replace the thermostat and it didn't correct the problems. I am assuming the fan limit control switch is bad. Can I replace it myself? It is a Honeywell switch. Should I remove it and take it with me to...
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
