 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
Check out some similar questions!
Board says it is a limit switch fault Furace goes into pre ignition, fan comes on and sometimes even the main burner ignites, but the blower will not come on... is this the blower motor or could this be a switch somewhere?
My Carrier 58RAV has and LED code #33 "Limit or Flame Roll Out Switch is Open" Instructions state "Open flame roll-out switch or fuse link, manual reset or replace". Where is this switch located? How do you manually reset it? Thank you
My carrier SS furnace blows the inline @amp fuse to the limit switch and then blows cold air continuosly . Is my low voltage supply faulty or do I have a wire grounding out somewhere.
I have Bryant upright furnace (Model 394GAW048100). Furnce runs fine for the first 4 or minutes in a cycle and then gas is cut automatically while the pilot is still on. After a few seconds, the gas again comes on and Furnace works fine for about 30 seconds, again gas is cut and so on. I changed...
My Carrier Furnace is continuously blowing and the heat doesn't work. The code was first, Limit Circuit Fault, tnen after changing the filter, it went to Limit Circuit Lockout -- and it is still blowing cold air. (Yikes!! It got down to 10 degrees outside)
View more questions Search
| Question Tools | Search this Question |
Add your answer here.
|
