Ask Experts Questions for FREE Help !
Ask
    pedro10's Avatar
    pedro10 Posts: 11, Reputation: 1
    New Member
     
    #1

    Sep 1, 2010, 06:39 PM
    Briggs & straton 6.25 hp lawn mower shutts off after a few minutes.
    I have a briggs & straton 6.25 hp self propelled lawn mower bought at sears. It's probably 4 or 5 years old. The mower starts but when it warms up for about 5 or 10 minutes it shutts off. I removed the carb and sprayed it with carb clnr and put it back and still doing the same thing. I noticed that if I spray some carb clnr on the inside of the carb the engine runs, but when in stop spraying it shutts off. Do you think it needs a new carb or is it internal in the engine?
    bronco78's Avatar
    bronco78 Posts: 2, Reputation: 1
    New Member
     
    #2

    Sep 1, 2010, 06:52 PM

    Try cleaning the lines and fuel filter
    DG's Avatar
    DG Posts: 1,375, Reputation: 109
    Ultra Member
     
    #3

    Sep 1, 2010, 07:59 PM

    I would say carb probably needs cleaned,but some of those carb are cheap enough its not worth trying to clean it.
    Mowbetter's Avatar
    Mowbetter Posts: 12, Reputation: 1
    New Member
     
    #4

    Sep 8, 2010, 11:28 PM

    Also check the gas cap, if it's not venting correctly, a vacuum will be created in the tank and fuel starvation will occur, usually in 5-10 minutes. Just crack the cap open a hain and see if that solves your problem.
    RennaisanceGuy's Avatar
    RennaisanceGuy Posts: 1, Reputation: 1
    New Member
     
    #5

    Aug 8, 2012, 11:06 AM
    I have a briggs 6.25 hp on a Sears self propelled lawn mower. I cleaned the filter, carb, and the fuel bowl and still sputtering. My daughter was the last one to use it so I had just about resigned myself to flywheel key replacement.

    I noticed that the throttle control was governed and the cable is fixed lever so you can only run in one speed. I manually pushed and held the throttle to the wide open position and no more problem. On further investigation, I discovered that the throttle cable attaching clip on the right side of the push bar assembly had come unlocked. I snapped it back in place and the throttle could now be opened using the throttle lever at the top of the push bar.

    99% of all trouble is the simplest thing. When will I learn... add adjust or check throttle linkage to the list of usual suspects.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

12.5 HP Briggs & Stratten Lawn Mower Engine [ 2 Answers ]

Hi- I have a strange problem with this engine. It starts and runs fine most of the time. But, every now and then it starts to smoke, lots of smoke out the muffler. The only way I can get it to stop is turn the engine off. It get into the carburetor through the Positive crankcase ventilator. I...

Briggs & straton twin 14 hp elect start lawn mower no spark ? [ 1 Answers ]

Replaced ignit. Switch ,new plugs ,fresh gas,good compression on right bank,kind of weak on left bank. Possibly washed down when flooded w/ gas. Did run for short while over fueled a bit. Dissasembeld and cleaned carb & cleared all ports and orifaces .even hot wired it but now there is no spark at...

Briggs & Straton riding Lawn Mower motor (see July 4th Post for more info.)wont run [ 19 Answers ]

As recommend I replaced eh Diode but still having problems It now blows out the 12 amp fuse when I plug it in to the Alternator wire that connects to the main source that flows through the diode. With the wire that connects the alternator unhooked it does not blow the fuse. Could the main...

Still trying to work w/ the 17hp briggs & Stratton lawn mower. [ 3 Answers ]

Went through and cleaned the coil up and the carb to just to be safe. Now have spark but it's not much and when tried to start it back fires through the carb. Need more great suggestions!

Briggs & Stratton 10 hp lawn mower engine? [ 1 Answers ]

Just wondering if the flywheel should be in contact with the starter at all times as it appears to be! It has eaten the flywheel gear off! Stupid nylon gear! Is there any after market alloy type replacement? Numbers off engine plate Model 28a707 Type 0113-01 Code 951103za


View more questions Search