Ask Experts Questions for FREE Help !
Ask
    baltimoreboy's Avatar
    baltimoreboy Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Sep 7, 2010, 08:23 PM
    troubleshooting state water heater?
    state water heater model PR 6 75 NRVET Z 150 gallon side vented. No hot water. Ignitor glows, flame starts up and then shuts off 2 seconds later. Red blinking light comes on. Till now, helped by turning switch off and on. Now no go.
    could it be the ignitor assembly? Is that difficult for homeowner to change?
    murray_clarke2's Avatar
    murray_clarke2 Posts: 7, Reputation: 1
    New Member
    		  
    #2

    Sep 8, 2010, 04:03 PM
    Sounds like a thermostat... you need a gas fitter plumber probably unless you are handy that way
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

State select water heater troubleshooting? [ 0 Answers ]

Propane water heater modelPR650CCVIT no hot water exhaust fan is running .on the controler the vacation light is on the one in the middle is on and the one on the far right is on that says very hot. I go and push the two arrows to relight it and then the center light should blink and fire up but...

State water heater troubleshooting [ 2 Answers ]

I can't get my State "Censible" 510E restarted after draining it and installing seismic braces. What should I do besides opening up the water supply and turning on the power supply? It's about 30 yearold. I told you my water heater problem shown above. I want you to answer my problem. Why do...

State select water heater troubleshooting [ 0 Answers ]

I have a State Select water heater. It is continually dripping water from the relief valve opening. Otherwise, it appears to be functioning normally. Can you tell me what the problem is?

State select water heater troubleshooting [ 1 Answers ]

I have a State Select electric water heater (M/N ES630DOLSG) that is not heating water. There is electricity (power) going to the unit. Is there a re-set button?

State select water heater troubleshooting [ 1 Answers ]

We have a State Select instant water heater that is about 3 years old. It serves a single small sink in a room that is rarely used. Tonight it started to leak. I unplugged it, shut off the water at the isolation valve and opened the drain valve. Less than 1/2-cup of milky-looking water came...

View more questions Search