Ask Experts Questions for FREE Help !
Ask
    rarando's Avatar
    rarando Posts: 2, Reputation: 1
    New Member
    		  
    #1

    May 25, 2010, 08:33 AM
    Irrigation system
    --------------------------------------------------------------------------------

    Irrigation system controller (Rain Dial #RD-1200 - James Hardie Irrigation). Also connected to system is a rain sensor.

    Used the "manual mode" for one zone with success yesterday. This a.m. the auto irrigation failed to run and I'm unable to modify any setting. Unable now to run manually. The "display" is frozen with code #1112 in upper right.

    All system "checks" have been performed; 9 Volt battery change, plugs, electrical connection. Please advise
    pants1's Avatar
    pants1 Posts: 14, Reputation: 1
    New Member
    		  
    #2

    May 27, 2010, 11:37 AM

    How old is the timer?
    rescuewil's Avatar
    rescuewil Posts: 1, Reputation: 1
    New Member
    		  
    #3

    Aug 6, 2011, 12:42 PM

    I have the same problem. My controller was installed in 1997. Did anyone figure this one out?
    Milo Dolezal's Avatar
    Milo Dolezal Posts: 7,192, Reputation: 523
    Plumbing Expert
    		  
    #4

    Aug 6, 2011, 11:32 PM

    Hit "Reset" and Reprogram.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

James Hardie Irrigation system. [ 3 Answers ]

How do I set the irrigation system to run every other day.

Irrigation system [ 0 Answers ]

Irrigation system controller (Rain Dial #RD-1200 - James Hardie Irrigation). Also connected to system is a rain sensor. Used the "manual mode" for one zone with success yesterday. This a.m. the auto irrigation failed to run and I'm unable to modify any setting. Unable now to run manually. The...

Wiring for an Irrigation System [ 4 Answers ]

I have an irrigation system with an underground well, a tank, a pump start relay switch, a timer and a pressure switch set to turn on at 20 psi and off at 50 psi. There are 3 zone valves connected to the timer. There is a separate zone for hose bibs that is not connected to a valve or the timer,...

Drip irrigation system. [ 2 Answers ]

Is a drip irrigation system cost effective? It takes four hour's to water the plants properly with a hose.

Irrigation System Problem [ 2 Answers ]

Five in-ground controllers (zones) handle my sprinkler system sprinklers. These controllers are in 5 different areas on my property. I noticed today that when zone one comes on that zone two comes on at the same time which never was the case in the past. As a consequence, the pressure is...

View more questions Search