Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Washer drain pipe keeps over flowing
[ 1 Answers ]
Hi, I have an old Amana washer. My problem is when I do a large load the 2" washer drain pipe overflows during the spin cycle. I snaked the pipe but the problem reoccurs. I have read some other related questions, some talk about the pump pumping too much water at a fast rate or just try not to...
Faucet sprayer vs dish washer air vent
[ 2 Answers ]
I want to replace the faucet for the kitchen sink. Ideally I would like dual handle, goose neck faucet and a sprayer. However, the hole where my sprayer would go contains the vent for my dishwasher and my disposal is also hooked up to this. Is this vent needed above the sink? Is there a way to...
Water constantly flowing from Drain Vent
[ 3 Answers ]
I have noticed water flowing from the water vent outside our apt, it has been running practically all day. Tried turning off the main water supply but it still runs. However, if I run the bath for a while it stops. Anyone know what the problem could be? Syngin
Dish Washer vent
[ 2 Answers ]
I just removed my dish washer vent to clean and forgot which way the vent is supposed to point. Is it to the rear facing away from sink or to the front facing the sink? Thanks!
Vent pipe for washer
[ 3 Answers ]
Hello again, I'm putting a washer where none has existed before (see Washer Height Discharge). You've answered my question about discharging over a door, but now the question about the vent. There is no vent stack near the washer. Can I run a 2" PVC vent pipe horizontally? I would have the... View more questions Search
|