[4322558]

I have repalced the nozzol and the fliter at the tank the way it look like it was never changed... so if I hold the reset button down it will fir up and run for like 3 minutes then it just kicks out and the red light comes on... I have bleed the air out so that's not the problme and this is the same problme from the begging of trying this stuff plase help if possible

[Joshdta]

Could be air getting in, check the nut at the filter. Or could be a dirty cad cell, try wiping it off with a rag.

[4322558]

Joshdta thanks I cleand the cad cell and its been running fine so far thanks agine

[4322558]

So the cell hardly ever goses if so how much do they run ? Thanks agine

[Joshdta]

They normally don't go bad to often, just need to be cleaned. Looking at the book here says between $19.75 for the one kit and $25.72 for the other.

[4322558]

Well it just lock out agine... mybe the cad cell is bad ? Because it ran a lot longer then it did the frist time after cleaning it

[4322558]

I clean the cell agine and its been running fine knock on wood