Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
I just replaced the cam in a briggs and stratton 15hp ic and it won't start have adjus
[ 0 Answers ]
I have a briggs & stratton 15 hp model #281h07 fly wheel key sheared off causing the engine to backfire then blowing the govenor and a part of the cam . I replaced the fly and cam and the gov and it won't start seems to be spinning OK but won't kick . What way does the flywheel rotate and have I...
KHOLER slip on tub spout
[ 14 Answers ]
I have a kholer devonshire tub spout that is a slip on. It slips on to a 1/2 copper and then there is a hex nut under it that you tighten. I would like some advice about properly afixing this. It does not seem to slip on very far and it seems like water would shoot backwards when the diverter is...
15hp ovc briggs stud pulled out
[ 1 Answers ]
I have a 15hp briggs with the ovc the rocker stud pulled out of the block. I ran a tap in but just won't stay tight pulled out.. any suggestions how to fix it?? I see they make a alum. Thread repair like a epoxy any one have luck or ideas? Thanks
Need to find a kholer toilet bowl
[ 3 Answers ]
I was trying to fix my toilet and I cracked the bowl. It is on a slab foundation and it drains out the back. It is very expensive to buy a new one and I'm wondering if there is anywhere I can just order the bowl? The model number is K4552. Thanks! View more questions Search
|