Another name for inducer housing

Check out some similar questions!

Bryant Plus 90i Inducer Housing Leaking - Water on the floor [ 0 Answers ]

A service rep came out and said it would cost 400.00 to replace inducer motor/housing. I asked him to try and repair it so he removed it, opened it and removed the old silicon sealant and put new sealant in it's place. The leak stopped for one month, but now there is water on the floor again. Not...

The Power Venter (aka Heat Inducer and Draft Inducer) will not start on Goodman. [ 8 Answers ]

FURNACE: Made by: Goodman Model #: GMPN080-4 THE POWER VENTER (this is what the Goodman manual calls it but other websites refer to this as the Heat or Draft Inducer): Made by: FASCO Industries 70219565 Type: U218 Volts: 115 RPM3400 Customer Part #: B2833001S

Inducer always on, but no heat [ 6 Answers ]

Hi! I am getting at the end of my rope. My problem: the thermostat calls for heat, the inducer starts, but the furnace does not light up. This started about two months ago, intermittently. Recently, it happens more and more often. One way to get it going was to play with the thermostat - first...

Bryant 350MAV inducer housing leaking [ 6 Answers ]

I have a 13 year old Bryant 350MAV gas furnace. The 2 halfs of the inducer housing are leaking water. Can these 2 half be pulled apart and resealed? If so what special type of silicone needs to be used if any?

Water in inducer housing [ 5 Answers ]

I have a York Diamond 90 that I am trying to figure out what is causing an issue with it. I seem to have an issue with a lot of condensation building up in the inducer assembly. There are three tubes that feed the condensate trap however it tube from the inducer drain is the one that is draining...

View more questions Search

Check out some similar questions!

Add your answer here.