Ask Experts Questions for FREE Help !
Ask
    cranberries07's Avatar
    cranberries07 Posts: 3, Reputation: 1
    New Member
     
    #1

    Feb 15, 2010, 05:40 PM
    GOODMAN GAS PAC pgb0300751
    IF this thing does die, is there a better unit to replace it with?
    It has the AC unit which works OK.

    I hate the unit being one the outside because lots of energy is wasted (for $1 energy spent I get about 70 cents of heat in the house)... duct work under the house, heat going up in the air. Although I like the circulating system, there has got to be a better one that is indoors.
    All of the registers are in the floors.

    Price for replacing the unit?? Can there be a replacement for the heater portion only?

Check out some similar questions!

Goodman gas pac pgb0300751won't ignite [ 2 Answers ]

Goodman PGB 030075-1 Previously when it would come on it would make a deep electrical buzz for a few minutes as if it is warming up, then I could hear the gas ignite and there would be a steam coming up for a few seconds out of its vent and then the fan would kick on. Last night it didn't...

Payne Gas-Pac heating unit [ 2 Answers ]

My mother has a Payne Gas-Pac unit, model PY1P, ser # 0203G31100. It appears by what I am told that the blower motor is roaring and needs to be replaced. The unit was installed in Jan 2003, and she is being told that she should not waste her money on replacing this. She is on a limited income and I...

Ruud gas pac [ 1 Answers ]

What will cause a gas pac to blink with one red light and only one burner will come on. Wait a little while and all burners will come on. But at night it will not come on at all.

Goodman gas furnace.relight after turning off gas at meter? [ 1 Answers ]

Hello, First time posting. Maintenance tech at local college. I'm working at home today though. I am relocating a gas line in the living room and need to turn the gas off at the meter. We have a Goodman gas furnance(duel fuel system)with electronic ignitnor. When I turn the gas to the house...

Error codes on bryant gas pac [ 1 Answers ]

This is for Northernheat ----- you told me to clean my flame sensor and so I did and also cleaned the place that it is attached and put a ground wire from the screw to the ground screw on the board post to make sure and I still get a code of 8 flashes that said it detected an error in the soft or...


View more questions Search
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.