Ask Experts Questions for FREE Help !
Ask
    buckshot7's Avatar
    buckshot7 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Feb 11, 2010, 09:03 AM
    Craftsman snow blower trouble shooting
    I have a Craftsman's 29 inch 9.0 horsepower snow blower. A neighbor's newspaper got caught in the augur. After removing the newspaper, the augur doesn't work. The power drive works OK and the sheer pins are OK. I thought it might be the drive belt but wouldn't the drive belt control both the augur and the power drive?
    buckshot7's Avatar
    buckshot7 Posts: 2, Reputation: 1
    New Member
    		  
    #2

    Feb 11, 2010, 09:07 AM
    Craftsman snow blower trouble
    I have a Craftsman's 29 inch snow blower. A neighbor's newspaper got caught in the augur. After removing the newspaper, the augur won't work. The power drive is OK and the sheer pins are OK. I thought it might be the drive belt but wouldn't the drive belt control both the power drive and the augur?
    crigby's Avatar
    crigby Posts: 4,343, Reputation: 107
    Outdoor Power Equipment Expert
    		  
    #3

    Feb 11, 2010, 10:19 AM

    Hi,
    Most but not all the times there are two separate belts. Without model #'s I cannot look it up, or attempt to anyway.
    Peace,
    Clarke
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Trouble shooting craftsman riding lawn mower [ 4 Answers ]

Have an 18 hp 42" cut craftsman riding mower (Briggs and Stratton engine) model 917.273762. The problem started three weeks ago. I was mowing and after an hour or so the engine started to bog down like it was getting too much gas. If I idled it lower it would continue to run. When I would ty to get...

Craftsman 22/5HP snow blower [ 4 Answers ]

Hi, I purchase and older model (1997) Craftsman 22' 5 HP dual stage snow blower, and I have not operated one before, but needed to have one to do driveway. Now my first time operating was yesterday after 6" to 8" snow storm. I was being very careful and set RPM's low, just above the TURTLE, and...

Craftsman 5.5hp snow blower won't start [ 10 Answers ]

I tried to start my Craftsman snowblower and it won't kick in. When I prime it it runs a few seconds then shuts down. The longer I prime, the longer it runs. Sounds like it is just running gas that I prime. I have electric start. My snowblower is a little over a year old. I used it last year....

Sears craftsman snowblower trouble shooting no spark [ 5 Answers ]

Have esears snowblower that is not getting any spark. Points are good and I think the plug wire is good and the plug is new. Any ideas

Craftsman 5.5hp snow blower won't start [ 1 Answers ]

Craftsman 5.5hp snow blower won't start. I have confirmed that my carb is plugged. I am pretty handy good instructions should get me through repairing.

View more questions Search