Ask Experts Questions for FREE Help !
Ask
    eimaj914's Avatar
    eimaj914 Posts: 1, Reputation: 1
    New Member
     
    #1

    Jan 9, 2010, 11:58 PM
    Gas furnace stays on
    The gas stays on full blast even when I shut down the entire furnace
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Jan 10, 2010, 12:12 AM
    Then you better shut off the manual gas valve and call for service ASAP.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem Furnace Blower Stays On [ 2 Answers ]

I have a Rheem Criterion II (Model RGPH 07NAMGR) with the main furnace blower that runs continuously. The IFC board (62-24084-82) is giving me the three blink error (middle green light between a green and orange bulb) which I believe indicates an open limit switch. I have check the three limits...

Gas furnace burner only stays light with front cover removed [ 10 Answers ]

I have a HEIL gas furnace located outside my house,I found that with the front panel removed it operates perfectly,however with the panel in place as normal the burner will light but will go out. Once I remove the panel I hear the gas valve click and its running perfect. I replaced the pressure...

Gas furnace model guh100AO16 runs cycle but fan stays on untail I unplug it [ 0 Answers ]

Gas furnace model GUH 100AO16 Arcoaire. Furnace runs cycle and heats up to temperature on thermostat but the induction motor does not shut off at the end of cycle which keeps the main fan motor running and blowing cold air. To get this motor to turn off I have to go to the furnace and unplug...

Furnace fan stays on [ 1 Answers ]

My furnace fan stays on forever, unless I do reset the power, any suggestion please? Thanks Green

Furnace stays on for 2 minutes [ 2 Answers ]

I have a digital thermostat and my furnace seems to stay on for only 2 minutes at a time. It does this approximately every 10 min. The programmed cycle rate is 5/hr, so starting up every 10 min makes sense. If the programmed temp is 72 F and the room temp is around 72 F, it will start up as...


View more questions Search