Ask Experts Questions for FREE Help !
Ask
    kdaniel3rd's Avatar
    kdaniel3rd Posts: 3, Reputation: 1
    New Member
    		  
    #1

    Jan 9, 2010, 11:30 PM
    What do I hook Y2 out, W2 out, W1 out, X/L, Bsg, Bs on a Luxaire Heat pump board to?
    Luxaire M# HL3A030F1 what do I hook Y2 out, W2 out, W1 out, X/L, Bsg and Bs coming out of board to. What purpose do they serve?
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Jan 10, 2010, 05:59 AM
    If you are replaceing the board you put the wires right back on the terminals you took them off on the old board.If not follow the wiring diagram on the unit.
    kdaniel3rd's Avatar
    kdaniel3rd Posts: 3, Reputation: 1
    New Member
    		  
    #3

    Jan 10, 2010, 06:49 AM
    Quote Originally Posted by hvac1000 View Post
    If you are replaceing the board you put the wires right back on the terminals you took them off of on the old board.If not follow the wiring diagram on the unit.
    No I just installed the Luxaire. I 've hooked up the Y, R, O, W, C to the board but I'm not sure where these other wires go. I usually install Goodmans and they don't have these connections. Y2 out, W2 out, W1 out, Bsg, Bs and X/L. The wiring diagram on the unit just shows the wires coming out but no connections.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #4

    Jan 10, 2010, 08:09 AM
    I believe some of those connections are used for an accessory.

    http://www.hvacforlife.com/editor_up...%20HP-HL3A.pdf

    Since you are a Luxair dealer or contractor I suggest you use the Lux site for your info.

    Luxaire - Heating and Cooling - Home Comfort Products
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Luxaire heat pump [ 2 Answers ]

I keep replacing 3 amp fuses on furnace and they keep blowing.Why

Trying to hook up T-stat to a whalen heat pump (model W602E) [ 1 Answers ]

I am trying to hook up a Honeywell RTH7000 to a whalen unit Model # W602E. The wiring diagram has faded to the degree of partial readability. The unit has 6 wires red, blk, brn, yellow, blue, orange I have: red to R Blk to C Brn to G (fan) Yell to Y1 ...

Heat pump wiring?control board [ 2 Answers ]

I got a call for replacing a T-stat... (for home). The York heat pump... after replace with the new one. I found the blown fuse at the airhandler... changed... now I have the blower up and now the electric heat is temporarily used but the unit outside is not running... In heating mode : the unit...

Luxaire heat pump [ 1 Answers ]

Older model luxaire heatpump will blow warm air in heat mode for several minutes then star blowing out cold air. Unit has new filter and coils are clean. The blower motor. Condensing motor and compressor run but blows cold air. Any suggestions on what problem could be?

View more questions Search