Ask Experts Questions for FREE Help !
Ask
    kyblue325's Avatar
    kyblue325 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 11, 2009, 10:12 AM
    Luxaire heat pump
    I keep replacing 3 amp fuses on furnace and they keep blowing.Why
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 11, 2009, 10:28 AM
    You have a short or heavy draw in the low voltage section of the furnace. This is why your fuse keeps blowing. Get a meter and check out all the circuits until you find the problem. This is what a service person would do.
    hvacservicetech_07's Avatar
    hvacservicetech_07 Posts: 1,083, Reputation: 75
    Ultra Member
    		  
    #3

    Oct 11, 2009, 10:29 AM

    Either a low voltage short or bad circuit board. Remove all of the low voltage wires (be sure to label what goes where) and replace the fuse again,power the furnace up,if it does it again it's most likely in the circuit board. Is this a gas furnace or just an air handler?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Hvac heat pump with aux/em heat- NO AUX HEAT [ 1 Answers ]

I have tried to install Honeywell 7500d thermostat. I get heat pump heat but no emergency heat although the termostate is calling for it. The installation manual says to see authorized agent if I have a dual 0/b on existing thermostat and another wire is attached to common. As of now, I have ...

Price check on Luxaire 3 ton 14 SEER AC/Heat Unit [ 2 Answers ]

Can anyone shed any light on the Luxaire 3 ton 14 SEER unit as to dependability. Your comments would be greatly appreciated. Also what is a good price range for this unit.

NO HEAT! Janitrol heat pump and AC system. Changing to Lux Thermostat. Wiring issue. [ 11 Answers ]

I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -

Luxaire heat pump [ 1 Answers ]

Older model luxaire heatpump will blow warm air in heat mode for several minutes then star blowing out cold air. Unit has new filter and coils are clean. The blower motor. Condensing motor and compressor run but blows cold air. Any suggestions on what problem could be?

View more questions Search