Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Plastic pipe brass fittings?
[ 6 Answers ]
Can I use brass compression fittings with 15mm plastic pipe? Thanks!
Toilet Flex Line with brass fittings at both ends
[ 1 Answers ]
My upstairs toilet flex line split at the plastic/nylon fitting underneath the toilet. We were out of town and the water ran for about four days. After three months of repairs to the house, I want to replace with flex lines that have brass fittings at both ends. I looked all over the internet and...
Brass pex fittings
[ 1 Answers ]
Can you reuse brass pex fittings again if the crimp doesn't take? If so , How do you get the crimp off? Thanks beth
Braided PVC tubing and brass insert fittings
[ 5 Answers ]
In the process of replacing a pressure tank on a well water system I have to make up some new connections using 1" ID and 3/4" ID braided PVC tubing and brass insert fittings with pipe clamps. What is the best way to get the inserts into the tubing? Would the heat from a hair dryer be helpful? ...
Removing brass fittings from Cast Iron pipe
[ 3 Answers ]
I need to snake the line under my bathroom sink. The problem is I have a dual sink setup. The vent pipe is also connected there so I have a cast iron cross fitting where the four meet (the two sink drains, the vent pipe, and the drain to the main line). I was attempting to remove one of the... View more questions Search
|