Ask Experts Questions for FREE Help !
Ask
    STEVEBEDNAR's Avatar
    STEVEBEDNAR Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 11, 2009, 04:05 PM
    Inducer motors for York Diamond furnaces
    I have a York Diamond 80 which when it starts up the seems to be a vibration that can be heard on the main floor(furnace is in the basement). Upon start up I can grab hold of the inducer motor and the noise goes away. Should I be concerned enough to go out and buy a motor and fan blade to have onsite? My furnace was installed new in July of 1998.
    STEVE
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Dec 11, 2009, 06:48 PM
    If I tell you not to worry it will break tomorrow. A slight vibration is somewhat normal. If you can find the motor get it and the fan blade attached to it but you might end up buying the entire inducer assembly.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Diamond 80 blowing cold air. [ 13 Answers ]

Hi All... Hopefully uou can help me out... I have a york diamond 80 gas furnace. It was working fine up until a few days ago.. It began to blow out cold air when the house clearly was not even close to "requested" temp. It turns on, starts the initial motor, the humidifer also kicks...

Inducer Motor on York Diamond 90 Keeps Running [ 4 Answers ]

I recently had the inducer motor replaced when it burnt out but I am having issues again. The inducer motor keeps running and won't stop until the whole system shuts down. Let me correct myself. I actually am reading about 26 V on the terminals of the pressure switch. The voltage on the...

Diamond 80 York Leaks Water [ 5 Answers ]

My Diamond 80 York central heat and air unit is leaking water under the carpet of the room where the unit is housed. It has saturated the carper in the front of the door to this room. Had repair person come out and he first told me it was the coil and that it was around $700 to replace a coil. ...

York Diamond 90 [ 1 Answers ]

I have a york diamond 90 and I have 4 code show what could it be

Goodman inducer motors [ 3 Answers ]

Any service guys out there. I can't fiqure this one out. I just installed this 90plus furnace last yr barley used in a guest house in n.c. system ran fine never turned on just when needed for winter in the basement cause the temp in charlotte nc is warm mosly around the whole yr. went to turn...

View more questions Search