Ask Experts Questions for FREE Help !
Ask
    rtaha's Avatar
    rtaha Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 12, 2006, 10:22 PM
    Matag Neptune washer stops...
    Help, my matag Neptune Washer
    Model # mah3000aww
    Serial #18138894sz

    Washer is stopping, and not completing a cycle, it also appears that it no longer spins the clothes, it is pumping the water out.
    I've taken the front off, and am trying to decide if the motor is bad or the motor control board is bad? The control board appears to be OK, nothing burned on it? How can I check the motor?
    Am I on the right track? Or are there simpler things to check?

    I see lots of problems on documented on many websites, but have not found this problem listed yet?
    Still looking.
    Doug B's Avatar
    Doug B Posts: 1, Reputation: 1
    New Member
    		  
    #2

    Dec 18, 2006, 02:19 AM
    I saw your post and I have the same problem. Have you found a fix yet?
    Doug B.
    rtaha's Avatar
    rtaha Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Dec 27, 2006, 09:39 PM
    Sorry my mail has been out for awhile and I have not checked back to this site.
    I did finally fix my washer - cost about $230.00 but works good. I found the motor control board in the bottom of the washer had burned out parts - they only sell the control board with a new motor - so I replaced both.
    Did the work myself so saved the 2 or more calls by a repair man.
    I may have a few pictures. E-mail me and I'll send them if it will help you.
    [email protected]
    Good luck...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

New matag drier won't heat [ 1 Answers ]

OK it works in the store lol. My 4 prong connecter is hot on both red and black my grounds are grounded and I replaced the 4 prong connecter still no heat it turns good jumped both grounds and still no heatchecked back of drier and black is hot red is hot checks hot on both and I am going crazy...

Washer Stops Spinning and Smells Like Smoke! [ 1 Answers ]

I have an older (1970's) Maytag washer that has an intermittent problem where it stops during the spin cycle and then smells like burning metal. I am guessing it is a short somewhere?? Is there an easy way to check the wiring on this beast or any other ideas as to what the problem may be? ...

Washer stops after a few minutes [ 5 Answers ]

We just moved our Kenmoore washer for recarpeting and now the washer will not rinse. Before it worked without any problems. When we load it up and set it to wash, before it reaches to Rinse/Spin, it stops. It seems it can not drain the water for it to rinse. Please help :( Thanks!

9-year old Matag Dryer won't start [ 1 Answers ]

My 9 year-old Electrical Matag dryer did not start, after I reset the circuit breaker, the circuit breaker trips when I plug in the power cord of the dryer. The resistance between two ends of the start switch(not pressed) is about 2k ohm when dryer door is closed, the resistance is open when dryer...

View more questions Search