 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
New matag drier won't heat
OK it works in the store lol. My 4 prong connecter is hot on both red and black my grounds are grounded and I replaced the 4 prong connecter still no heat it turns good jumped both grounds and still no heatchecked back of drier and black is hot red is hot checks hot on both and I am going crazy here checked the breaker both wires hot
|
||||
|
||||
|
Make sure you have your cord connected properly. You should have two hots one neutural, and a ground. The red and black are the hots, the white is the neutural, and the green is the ground. If you have verified this, check to make sure that you haven't triped a fuse, and that you are indeed getting your two 120 volt potentials at the cord. Reading between the black and red connector on the cord end, you should read 220-240 volts, if you do not, and read 120 volts to ground on both sides, then there is a problem. The two hots are on the same potential.
Check that first. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
I have a Janitrol A/C and heat pump system. I replaced the thermostat with a Lux T9000LC The A/C works fine, but the heater does not. I have it wired as follows: G - Green Y - Yellow W - White RH - Pink B -
How do you change from Apollo gas heating system to electric heating system?
My 5 year old Maytag drier squeaks something awful when we turn it on -- its so loud I can hear it outside. My husband took it apart and used a heavy duty non silicone spray on the wheel that makes the drum spin, but it only stopped it for 1 cycle. Otherwise there's nothing wrong with it. ...
Need Help on Refrigerator cooling issue. My maytag MSB2554AR side by side is not cooling the refrigerator side. I have found that the back side of the freezer gets frosted up. I cleaned the coils in back and defrosted the freezer coils. After about t weeks I am running into the same problem. Any...
My 9 year-old Electrical Matag dryer did not start, after I reset the circuit breaker, the circuit breaker trips when I plug in the power cord of the dryer. The resistance between two ends of the start switch(not pressed) is about 2k ohm when dryer door is closed, the resistance is open when dryer...
View more questions Search
|
