Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Charging system
[ 1 Answers ]
I have a 11 hp Craftsman model 502 and the wires at the Briggs have been cut but they both produce power when running, one low voltage and the other high. Any idea where they should go to charge the battery?
Charging system
[ 2 Answers ]
I have a 98 chevy 1500, has a 105 amp alternator that is not doing the job now, I had it tested at different auto parts stores all say its not working. I have a snow plow mounted and only do a few driveways but push the switch to operate the plow and it uses a lot of power and that's typical it...
Mazda MPV Charging system
[ 1 Answers ]
I have a 1990 MPV, the voltage regulator failed (which meant a new alternator). After renewing alternator the battery failed, renewed it. NOW after starting the engine the alternator charges 14.5 volts for a few minutes then quits charging (12 volts). The alternator will begin charging after an...
1993 Mazda MPV charging system
[ 3 Answers ]
MPV, 3.0L V6. Had an issue with the charge light and fuel light coming on at the same time (gas tank half full). Voltage at the battery with engine running was 11.3 volts. Replaced the alternator and everything was fine, voltage showed 14.0 volts. Went for a short drive and charge and fuel... View more questions Search
|