Ask Experts Questions for FREE Help !
Ask
    enzo711's Avatar
    enzo711 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 4, 2009, 06:25 AM
    Pump Wiring
    How do you wire a Pentair 110V/220V 1HP pump to 110V? The diagram indicates connecting to BROWN at the top and L2. There is a brown wire on the bottom but no screw to connect to. The top wire is WHITE but again no screw to connect to. There are only two screws to connect to and they are labeled L1 and L2.
    bchbuumm's Avatar
    bchbuumm Posts: 4, Reputation: 1
    New Member
    		  
    #2

    Jul 12, 2009, 06:12 PM
    Look at your diagram and if it show brown to L2 then you pull it off whatever tab its on and slide on a tab of L2... and the same goes for the other wire. Whatever the diagram shows.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #3

    Jul 16, 2009, 05:03 AM

    Since you didn't give a Model#, do you see it here?:
    Pentair Water Pool and Spa
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Wiring pump motor [ 6 Answers ]

How do I wire a 240 volt 2 stage pump motor where does white black red wires go thanks

Wiring a water pump [ 5 Answers ]

The manufacture just told me: The item is pre-wired at 120 volts And you can re-wire it for 230 volts the manual will have instructions to re-wire for the 230 volts My apologies.. this can Not be wired for 220 My breaker panel has a 50amp breaker for the pump. I guess it A 220 line. ...

Wiring for heat pump [ 1 Answers ]

How do I wire a heat pum thermostat

Underground wiring - well pump [ 1 Answers ]

Hi I am trying to run this AWG 6-2CU UF-B underground feeder cable from the basement to an outdoor well pump controller. This is a three wire (two isolated + ground) cable that is to be connected at 240Vac from the main panel and routed out for about 200ft. The controller is supposed to limit...

Pool pump wiring [ 1 Answers ]

My electrician made a 4' mistake in running a new line to our pool. Instead of going to all the trouble of running a new line I would like to just replace the plug wire coming from the pump. I don't know squat about this. What does SJTOW mean?

View more questions Search