Ask Experts Questions for FREE Help !
Ask
    Thomas Cramsey's Avatar
    Thomas Cramsey Posts: 1, Reputation: 1
    New Member
     
    #1

    Jun 5, 2009, 02:40 AM
    Removal of crankshaft nut on Craftsman 32cc gas blower
    How do I remove the crankshaft nut that is located on the end of the crankshaft of a craftsman gas blower 358.797180? Does the nut turn off, if so what direction, and how do I stop the shaft from turning while unscrewing the nut. Or is the nut pressed on. I need to remove this nut to replace the starter pull rope assembly.
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
     
    #2

    Jun 5, 2009, 11:12 AM

    Model # and serial # would help. You can go to Owner's Manual | Find Product User Manuals - Managemyhome.com click on Craftsman or gas blower and download a manual. Because of engine rotation mant nuts like this are reversed thread, turn clockwise to loosen.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Starter removal in Craftsman lawn tractor [ 3 Answers ]

I have a 19.5 hp Electric start 42" mower, model no. 917.271820. The starter needs replacing. How can I do this? What tools to use? Thanks in advance bob144

92 Voyager 3.0, crankshaft damper bolt removal [ 7 Answers ]

I am changing the timing belt on a 92 Plymouth Voyager, 3.0 liter Mitsubishi engine. I have been unable to break loose the 22mm bolt attaching the damper to the crankshaft. Have tried breaker bar and 4 lb. hammer, breaker bar and 2 ton hydraulic jack, air impact wrench (230 ft. lbs. torque only),...

Sears weedwacker 32cc [ 1 Answers ]

I have a sears weedwacker 32cc. Model #358-791590. The pulley string on the inside of the motor assembly has broken. My question is how do I get the pulley off in order to replace the string assembly. I have taken out all the bolts from around the casing.

Crankshaft pulley removal [ 3 Answers ]

Well, I've decided to do a major service by myself and in my research, I found that the crankshaft pulley is a very difficult thing to remove. This is for a 95 civic DX SOHC. Napa autoparts does not have a tool for the job. I have seen some online, but am wondering what others recommend. Some...

1996 ford taurus Duratech crankshaft removal [ 1 Answers ]

I am trying to help a friend out w/ his 96 Taurus Crankshaft. It is the original crankshaft and was originally a two piece unit. Anyway, Ford has upgraded the pulley totally and no longer has rubber for a dampener. In the pulley All I know is that I removed the crankshaft assembly which included 3...


View more questions Search