Ask Experts Questions for FREE Help !
Ask
    summerbarbie71's Avatar
    summerbarbie71 Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Sep 13, 2006, 09:14 PM
    No power to thermostat
    I recently had a pool heater installed. The electrician installed it to the incorrect voltage. We found this out when we tried to power up the pool heater. Right after he came back and installed it to the correct voltage, the thermostat and heat pump to my house quit working. It is getting no power. I called the electricians office and told them what happened. The supervisor came to my house while I was not home and checked it. He said my heat pump circuit breaker is fine. Could it be coincidence that my heatpump and thermostat quit working at the same time as the electrician hooked up the pool heater to a higher voltage? What could be the problem?
    rickdb1's Avatar
    rickdb1 Posts: 185, Reputation: 15
    Junior Member
    		  
    #2

    Sep 14, 2006, 05:56 AM
    You need to find the breaker for the heatpump and see if it's tripped. Does the inside unit work? Is it blowing air?
    summerbarbie71's Avatar
    summerbarbie71 Posts: 2, Reputation: 1
    New Member
    		  
    #3

    Sep 14, 2006, 05:35 PM
    Thank you so much for replying!! No the inside unit does not work. No it is not doing anything. It turns out the circuit board to the inside unit is fried. Burn't black! I am still trying to figure out if the pool heater wiring was to blame or if it was coincidence that the circuit board burnt on the same day. What would cause the circuit board inside to burn like that?
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

No power to thermostat [ 19 Answers ]

Hi, I was trying to replace my old stat with a new programmble one. I had turned off the furnace before installing new one. But the new one didn't work and so, I put the old one back on. But the old one does not power now and display on the old stat does not come up. Can any one help me here...

Power dvd 5 [ 6 Answers ]

Right, I need some help with an error I keep getting while trying 2 watch dvds. It says that my " tv out put port of my diplsay card is not working properly" and I don't know how to solve this problem.. can anyone help?

No power after thermostat replaced [ 3 Answers ]

Ok... I know better... but since I was dealing with low voltage... I figured no harm... WRONG! :eek: I should have turned off the breaker when replacing my thermostat... enough said. I replaced my thermostat (simple comfort 3001) with a honeywell RTH6300b because the simple comfort display was...

No Power to Thermostat [ 2 Answers ]

We have two electric central A/C units - one upstairs, one down. We discovered that the upstairs A/C unit was running 24/7 making the upstairs very cold (and a $680.00 electricity bill). The original Honeywell programmable thermostat was not shutting it off regardless of the room temp -vs-...

View more questions Search