Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Flame sensor
[ 3 Answers ]
Need to clean flame sensor on Amana 80 Command. Where is the flame sensor? How should I "clean" it?
What does the flame sensor look like
[ 3 Answers ]
What does the flame sensor look like and where is it located?
Bad Flame Sensor?
[ 1 Answers ]
Thermostat calls for heat Blower comes on for 30 seconds Ignitor glows Gas kicks on & gas ignites in first burner Travels down the to the other three burners including the last one where the flame sensor resides Furnace stays lit for a few seconds and then goes out with a lockout code The...
Flame sensor
[ 1 Answers ]
I have a York Diamond 80 upflow furnace. I think my flame sensor is bad. I checked my wire to the sensor with my meter ( I just completed classes in HVAC) and got 90 on the volts. Just wanted to make sure I am replacing the right part. The flame kicks on and goes out about 5-10 seconds later.
Flame Sensor
[ 5 Answers ]
How can I replace a flame sensor in a Trane heating unit? View more questions Search
|