Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
Circuit breaker loads
[ 2 Answers ]
How many conductors (of the same size) are allowed per circuit breaker? I thought more then one as long as the load requirements were met. A friend told me he thought only one wire (circuit) per breaker; is this a NEC rule? :)
Furnace on a 15amp breaker
[ 7 Answers ]
We purchased a house and have been going through the eletrical and cleaning up some of there "mess" OK lazy ness to make sure evreything is correct. We have the majority of it all cleaned up. However, we came across something that seemed odd. The Furnace (gas) is on a dedicated 15amp breaker. ...
15AMP Breaker used instead of 20AMP -ok?
[ 4 Answers ]
We just had an electric gate installed that extends across our driveway. I noticed that the installer used a 15 amp breaker switch to connect to for power (the gate is the only device on this breaker). In looking at the manual last night the installation instructions call for a 20 AMP breaker (the...
Switching from 15AMP breaker to 20AMP
[ 6 Answers ]
I am contemplating switching my 15AMP breaker into a 20AMP breaker because the lights flicker in my home office because my computer and printer eat up a lot of power. If I switch breakers, will this help my power problem? Or I am limited to the gauge of the wires in the wall? Thanks for the...
Main Breaker loads
[ 4 Answers ]
I am trying to figure the capacity of my breaker box. Looking at the main breaker and lugs, there is two sides. So my question is, if the main breaker is a 100 amps; is the capacity of the box 100 amps per side (being 200 amps total), or 100 amps total and only 50 amps per side. The breaker... View more questions Search
|