Ask Experts Questions for FREE Help !
Ask
    BenNga's Avatar
    BenNga Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Dec 10, 2008, 06:20 PM
    Replace the Breaker?
    So how do I replace this 10Ka 120/240V breaker since my dryer will not heat and I have replaced all its parts. I think I have to replace the breaker (2 pole - single breaker), because when I tested it with my meter, sometimes I would get 120 readings and other times 230 - 240 readings.
    bones252100's Avatar
    bones252100 Posts: 253, Reputation: 29
    Full Member
    		  
    #2

    Dec 10, 2008, 06:37 PM
    Forget the breaker! If you are getting power at all, the breaker is fine. The breaker simply connects or disconnects. The breaker itself does not control voltage control. The erratic voltage readings reported depends on which legs of the receptacle were being read at the time. It is most likely the problem is still in the dryer. Concentrate on that issue & ask again with dryer model details and what has been done thus far. The electricians are here to help.
    stanfortyman's Avatar
    stanfortyman Posts: 5,598, Reputation: 279
    Electrical & Lighting Expert
    		  
    #3

    Dec 10, 2008, 06:56 PM
    Where exactly did you test for voltage?

    What "all" parts did you replace in your dryer? And WHY?
    tkrussell's Avatar
    tkrussell Posts: 9,659, Reputation: 725
    Uber Member
    		  
    #4

    Dec 11, 2008, 06:06 PM
    Exactly,

    And WHY?
    Parts changing is not troubleshooting the problem.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

How do I replace a 30 amp breaker with a 20 amp breaker? Must I replace the wiring? [ 15 Answers ]

I have purchased a GE built-in oven to replace the 60 year old oven that was installed when the house was built. The original oven uses a 30 amp breaker. The salesperson told me I must change the breaker to a 20 amp to accommodate the new oven, but he's unsure whether the wiring must be changed as...

I just replace my breaker box but it didn't have a main breaker is that safe ? [ 5 Answers ]

On the box it says it is a 100 amp breaker box and I have 1 50 amp breaker .2 30 amps breaker and 3 20 amps breakers if I add all the breaker it is 170 amps and my breaker box is for 100 amps is that how it works? Do I need a bigger breaker box? Is it unsafe...

Replace a two pole breaker in main panel box [ 1 Answers ]

I need two replace a bad two pole breaker in main panel boxwhat tools do I need

Can I replace a 15-amp breaker w/a 20-amp? [ 4 Answers ]

Newb question - My home is less than 2 years old. I'm not sure which gauge wire it is wired with (14 or 12). I have 3 upstairs rooms all on one 15-amp breaker. Both of my kids rooms and our workout room. My wife has a tanning bed (120v, 15a) in the workout room. Sometimes, the breaker...

How do I safely replace circuit breaker? [ 3 Answers ]

In my garage I have two separate overhead light bulb sockets, each is connected to a separate wall switch. One works, the other does not. Using a tester, there is no power at the socket that is not working. I have replaced the wall switch and the fixture, it still does not work. The last thing...

View more questions Search