Ask Experts Questions for FREE Help !
Ask
    mbushart9's Avatar
    mbushart9 Posts: 1, Reputation: 1
    New Member
     
    #1

    Dec 6, 2008, 07:53 AM
    Burners on furnace won't stay on then try refiring
    My burners on my furnace light stay on about two seconds go out for about 5 seconds then try to relight, this process keeps happening until I turn unit off.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
     
    #2

    Dec 6, 2008, 08:31 AM
    Quote Originally Posted by mbushart9 View Post
    My burners on my furnace light stay on about two seconds go out for about 5 seconds then try to relight, this process keeps happening until I turn unit off.

    Try cleaning the flame sensor if so equipped.
    Attached Images
     

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

I have a rheem furnace, new motor, I'm getting faint heat, burners won't stay lit [ 2 Answers ]

I have a new motor, thermostat is only a year and a half old, heat comes on, burners won't stay lit. Getting faint heat from vents on first floor level of house

Burners do not stay lit. [ 3 Answers ]

Burners do not stay lit. I have a brand new Goodman GPG13 package unit with a 138,000 BTU natural gas furnace. The furnace has six (6) burners and an electronic spark ignition. All burners light, then (after about one (1) minute) the bottom burner or bottom two burners sputter or just go out may...

Furnace trouble. Pilot lights. Burners light but then go out. Evetually stay on [ 2 Answers ]

Hi all, I searched through this site a bit and found some helpful topics, tried a few things and I'm still have the same trouble. I have a Bryant furnace that uses a Johnson Controls G779LHA-1C Ignition Control. The ignition control is new, I just replaced it a week ago. It's hooked up so...

Why will my burners not stay lit [ 1 Answers ]

My forced air furnace does not stay lit when the heat is turned on. I climbed into the attic where it is located and had my wife set the thermostat to heat. I observed the burners light and watched the Honeywell limit switch start to do it's thing but after about a minute the limit switch...

Burners won't stay lit [ 2 Answers ]

-- need more help in figuring out flame sensor or roll out switch - Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)---burners light for 1 or 2 seconds, then go out


View more questions Search