Ask Experts Questions for FREE Help !
Ask
    halfpt's Avatar
    halfpt Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Oct 22, 2008, 07:36 AM
    I have a rheem furnace, new motor, I'm getting faint heat, burners won't stay lit
    I have a new motor, thermostat is only a year and a half old, heat comes on, burners won't stay lit. Getting faint heat from vents on first floor level of house
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Oct 22, 2008, 12:10 PM
    Exact model number of furnace?
    Also post code (number of flashes) on circuit board.
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #3

    Oct 22, 2008, 04:08 PM

    Typically if the burners ignite but fail to remain lit then I start with the flame sensor. Pull it out, clean it with some sandpaper and reinstall. If this is the problem then cleaning it will have you all warm and toasty in no time.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Rheem furnace blower motor won't turn on [ 2 Answers ]

My furnace blower motor will not turn on. The troubleshooting guide says to replace blower motor but the diagnostics says the Limit Switch is Open any ideas

Rheem furnace has no heat. [ 1 Answers ]

:cool: hi,out there.bob,here in cheyenne,Wyoming.it's christmas day and we have no heat.we have a rheem criterion 2 gas furnace it doesn't have a pilot light .the furnace turns on and the fan blows,but only blows cold air even with thermostat set on heat.can someone out there help us?thanks MERRY...

Furnace trouble. Pilot lights. Burners light but then go out. Evetually stay on [ 2 Answers ]

Hi all, I searched through this site a bit and found some helpful topics, tried a few things and I'm still have the same trouble. I have a Bryant furnace that uses a Johnson Controls G779LHA-1C Ignition Control. The ignition control is new, I just replaced it a week ago. It's hooked up so...

Honeywell thermostat heat/cool in Rheem 2 stage furnace? [ 1 Answers ]

I have a Honeywell 1 Heat/1Cool thermostat (TH6110D1013) that I would like to use with a Rheem 2 stage gas heat furnace. I think it is possible but would I get the same benefits as having a thermostat with 2 heat/1 cool? Would I just connect the W terminal on the Thermostat to the W2 on the...

View more questions Search