Ask Experts Questions for FREE Help !
Ask
    dvqjimbo1's Avatar
    dvqjimbo1 Posts: 28, Reputation: 2
    New Member
    		  
    #1

    Dec 18, 2006, 04:14 AM
    Burners won't stay lit
    -- need more help in figuring out flame sensor or roll out switch - Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch)---burners light for 1 or 2 seconds, then go out
    labman's Avatar
    labman Posts: 10,580, Reputation: 551
    Uber Member
    		  
    #2

    Dec 19, 2006, 05:57 AM
    The flame roll out switch will be a little ceramic dodad with wires right where the flame will hit it. If it doesn't send a signal to the board, it will shut the gas off in a few seconds. Clean up the metal contacts. Replace it if broken or cracked.
    rickdb1's Avatar
    rickdb1 Posts: 185, Reputation: 15
    Junior Member
    		  
    #3

    Dec 19, 2006, 08:57 AM
    Sounds like the flame sensor. Are the flames rolling out? If so, you may have other problems... Very simple to bypass the roll-out for testing...
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Carrier Furnace - Burners turn on and off [ 2 Answers ]

On my Carrier furnace (model 58G5100-2) the igniter starts the pilot, and most times the pilot starts the burners after a minute or two and then the blower motor starts. Other times, pilot lights the burners which burn for a minute or two, stop and then start again... and after a few minutes...

My pilot light won't stay lit [ 6 Answers ]

Help,I have two problems.. My upstairs furnace pilot light will light,and after holding down the pilot button for about 3-4 minutes(it says one minute,but it won't stay lit after only one)it stays,but will go out again in a day or two... The furnace for the downstairs won't light at all.. I can't...

Burners won't light, or, stay lit [ 3 Answers ]

1'st time trying to turn heat on with new furnace-- hot surface ignition system -- burners don't light , or, stay lit -- can't tell which. Any special sequence needed to light? Any help appreciated

Feather lit weed eater [ 2 Answers ]

I have a feather lite weedeater. It won't prime... it acts like the hoses are hooked up backward? They seem to fit correctly... could something be pluged up to keep the gas from flowing into the prime bulb?

Burners won't... Follow up info [ 3 Answers ]

Burners light for couple seconds, then go out Weather King --- ICECO --- 80 PJ --- forced air --- Honeywell valve (on/off switch) Burners try to light on 1'st attempt, lights for couple seconds then out on2'nd attempt. Brand new furnace. Looked in installation manual -- says stuff...

View more questions Search