Ask Experts Questions for FREE Help !
Ask
    wiremanha's Avatar
    wiremanha Posts: 2, Reputation: 1
    New Member
    		  
    #1

    Nov 15, 2008, 09:42 AM
    Over flow Goodman furnace
    On Goodman furnace GMP N100-4
    When the furnace gase valve comes on the flame rolls out of the chamber, after a while the switch clicks off. So the furnace won't work at all until it is reset.

    Thank You:(
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #2

    Nov 15, 2008, 11:07 AM
    Call for ON SITE service immediately. You have a very dangerous situation.
    MarkwithaK's Avatar
    MarkwithaK Posts: 955, Reputation: 107
    Senior Member
    		  
    #3

    Nov 15, 2008, 08:43 PM

    Yup. More than likely your exchanger is cracked.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Goodman furnace GMNT080-4 furnace runs good for a while then has to be manually reset [ 5 Answers ]

I have a Goodman GMNT080-4 (90%). I'm having the same problem As Streatherg did back in the Nov 2006 question. I reviewed his article and tried Every thing on there but seems to be doing the same thing. The furnace kicks on for about an hour then locks out and has to be manually reset threw...

Goodman Furnace [ 2 Answers ]

My furnace worked fine last season, Air Conditioning worked great over the summer. This year I turned the switch to heat and the blower ran for about two minutes but then shut down? I went and looked at the furnace and I shut it off and turned it on again. The blower starts but the igniter does lit...

Goodman Furnace-again [ 5 Answers ]

I have a Goodman GMP150-5 with A/C the upper fan comes on, the glow plug lights and ignites the gas jets but the big fan on the bottom won't start up, and therfore the gas jets go out. The basement flooded overnight but not enough to reach the circuit board even though the wiring got wet somehow. ...

Goodman Furnace did come on [ 1 Answers ]

I got a Goodman GMH950904cx furnace. I installed it about a month ago, and it worked fine when I turned it on. Recently, the weather chilled and I tried to turn on the furnace everything worked except there is no gas coming up. The motor runs, and ignitor light up but no GAS. The gas tank is...

Goodman furnace [ 17 Answers ]

I have a goodman furnace. Forced air. No a/c. I turn the power on and she starts. Thermostat is off. No wires are crossed that are visible. The pilot does not ignite but the heating element is on. No gas seems to be coming through. Any suggestions? The furnace is only a year and a half old.

View more questions Search