Not your question?
Ask your question
View similar questions
Add your answer here.Check out some similar questions!
New sink sprayer will not thread onto sink fitting
[ 9 Answers ]
I want to install a new sink sprayer onto a faucet where the old one was removed and capped off. The new sprayercompression fitting seems to be too big. Is there an adapter? I have never seen anything like this before. It also seems like the faucet stem is not only smaller but too short to get...
Condensate Drain - Smelly Sink
[ 2 Answers ]
I have a 7 year old house located in Texas. The upstairs air handling unit has a drain for condensate that empties into my wife's sink between the sink drain and the P-Trap. Over time some nasty stuff has grown in the line and the smell comes up through the drain. I'm at the point where I can no...
Connector for NPT connection on shower, slip fitting or not?
[ 5 Answers ]
I'm installing the shower valve. Is it better to use a threaded slip fitting, or just a standard non-slip type? My worry is if I don't tighten the non-slip type enough, it will leak and I won't be able to tight anymore without undoing all the plumbing.
How to get the nut over the tailpiece on the sink
[ 1 Answers ]
I have been replacing the "basket" on my kitchen sink and all was fine until I got to the "replace the nut over the tailpiece on the sink" the old on came off and the new on that came with the new basket does not want to slip over the lip on the tailpiece, the instructions in the package do not say...
Stub out to tailpiece drain connection
[ 1 Answers ]
I am in the process of replacing a bathtub on a slab in a one story house. The cutout and stub is already there. I removed the old PVC fittings and lead in the stub out. The connection dimensions for the new tub drain are a little different from the old tub. What kind of PVC fitting do I put in... View more questions Search
|