Ask Experts Questions for FREE Help !
Ask
    marshal479's Avatar
    marshal479 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 3, 2008, 05:01 PM
    New York Heat Pumo
    I just had a company put in a York 13 SEER 2 ton Split System Heat Pump (model: (Z)THGD24S21S1A). I currently have a Honeywell Vision PRO 8000 (model: TH8320U1008) which worked great with my old system. It is only 2 years old and the company put a cheaper York thermostat on the new heat pump until I could find the directions for the Honeywell because they believe it may not work with the York.

    Does anyone know if the unit I just had put in will work with the Honeywell Vision PRO 8000.

    Thanks
    Jason
    EPMiller's Avatar
    EPMiller Posts: 624, Reputation: 37
    Senior Member
    		  
    #2

    Nov 3, 2008, 08:18 PM

    It will work. Go to the Honeywell website and download the installation instructions for the thermostat and read them. It's in there.
    hvac1000's Avatar
    hvac1000 Posts: 14,540, Reputation: 435
    Heating & Air Conditioning Expert
    		  
    #3

    Nov 3, 2008, 09:10 PM
    Follow this link to your manual

    Install

    http://customer.honeywell.com/techli.../69-1896EF.pdf


    Operation

    http://customer.honeywell.com/techli.../69-1894EF.pdf
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York Stellar Gas furnace Blower comes on NO heat [ 2 Answers ]

I am at a loss, furnace has a auto ignition, has tried to restart unit, but pilot does not appear to be one, air blows out of the vents, but no heat. :confused:

York heat pump [ 1 Answers ]

I have a older york heat pump that a technician came out to try to repair. He said the board was bad and tried to wire it so that the out side heat pump would run to keep the House cool. Well I found out what had happened to the board (Relay was pulled away from the circuit board from the fan wire...

Heat Pumo high pressure switch [ 1 Answers ]

Heat will work fine through a cycle but after it completes cycle it goes off on the high pressure switch. It is a Ruud. The indoor filter is clean and coils on condensing unit are clean. I have to reset condensing unit and it will run fine through that cyle then repeats problem. Any ideas as to...

York furnace - No ignition,no heat [ 4 Answers ]

I have a York Gas Furnace (model# P2MPD14W08001B, 12yrs old) giving out no heat. I did basic troubleshooting and realised system was not igniting; replaced ignitor (changed original 4-5 years ago) - fired up initially and then went out after running for about 30 minutes. I cleaned the flame sensor...

York heat pump changing from 70 to 72 degrees [ 1 Answers ]

I have a york heat pump and a honeywell model 8300 thermostat. I also have a electric furnace as a backup aux heat. I have the thermostat set to go to 70 at 11:30 pm then at 9:30 am to go to 72. Then heat will operate in this mater. 1 At 9:30 heat pump will start 2 About 1 min later the aux...

View more questions Search