Ask Experts Questions for FREE Help !
Ask
    ngitter's Avatar
    ngitter Posts: 1, Reputation: 1
    New Member
     
    #1

    Aug 9, 2008, 11:20 AM
    15.5hp B&S won't start
    I have a 48" Bobcat with a 15.5hp Briggs. It worked flawless for 4 years and now won't start up on the second pull like it has always done. I have to choke it and pull the cord, then release the choke and pull about 10 more times before it starts up. Gas actually drips out of the muffler when it starts.
    I tried new air and gas filter, new spark plug with no change at all.
    Any suggestions?
    KISS's Avatar
    KISS Posts: 12,510, Reputation: 839
    Uber Member
     
    #2

    Aug 9, 2008, 08:57 PM
    Check for spark, otherwise take off, disassemble and clean the carb.

    Common cause is fuel left in tank without a fuel stabilizer.

Not your question? Ask your question View similar questions

 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

1997 honda civic dx won't crank won't start [ 17 Answers ]

I have a 1997 honda civic dx 5 speed. Yesterday car was fine, started strong and drove strong. I parked car last night and about 4-5 hours later tried to start it. When I turned the key in the ignition there was no crank at all. I can hear a little hum and then a click but that's all.

Saturn won't start, power locks won't work, radio resets itself. [ 4 Answers ]

My 99 Saturn has had some starting problems in the past. It would sometimes not start but if you let it sit from anywhere from 45 minutes to 24 hours, it would eventually start. Or, after having Dad look at it, we could tap the starter and it would work. So we thought it was the starter. I...

93 Civic won't start, turns over but won't crank [ 4 Answers ]

I have a 1993 honda del sol SI that I converted to manual, before the swap everything was fine, cranked up, my battery and alterntor were going bad but would crank up, after the swap, it turns over but nothing happens,I'm not gettting any spark at all, I went and got a new distributor but still...

Kenmore he4 panel won't work and dryer won't start [ 1 Answers ]

I have had the circuit board/panel replaced once on my he4. I had only 2 weeks left on the warranty and figured it should be OK once it was fixed. They wanted another $200 to renew the warranty! Didn't have the $$ at the time. Anyway, the same darn thing is happening... you have to push the buttons...

Crx del sol won't start? [ 1 Answers ]

Hi I have got 1992 del sol,the problem is started two days ago when I took it to shopping went back to my car headlights side signal everything working but the engine wanted start.so I tried jump starting still nothing.so I left my car at the car park and went back to my car yesterday and tried...


View more questions Search