Ask Experts Questions for FREE Help !
Ask
    Gerald70's Avatar
    Gerald70 Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 8, 2008, 07:44 AM
    Toilet Flange Installation
    In a new construction concrete floor the 3" pvc toilet drain line is installed at a slight angle causing the toilet flange to likewise be at an angle rather than level with the floor. How can I install the toilet flange in a workable manner?
    ballengerb1's Avatar
    ballengerb1 Posts: 27,378, Reputation: 2280
    Home Repair & Remodeling Expert
    		  
    #2

    Jul 8, 2008, 05:51 PM
    How high is the high edge of the flange off the floor and is it a glued in flange? A slight angle may not be a problem since the flange uses the wax ring to make its seal and the johnnie bolts will be able to lean.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Installation of a twist and set flange [ 9 Answers ]

I am in the process of remodeling my bathroom and after the demolition the flange for the toilet drain sets up to high. I will have to remove the old one and replace it with a new one lower to the concrete slab. I found a cast Iron "Twist and Set Flange" and was wondering if this is easy to...

Toilet flange installation [ 6 Answers ]

I am going to install a toilet in the basement that already was rough-in when the house was built. I have a cast iron pipe for the toilet sticking out about 10". I am going to install ceramic tile on the floor, do I cut the pipe down to the concrete floor and install the flange and butt the tile...

Toilet flange level for installation [ 3 Answers ]

I am installing a toilet in new construction where the flange is set at the subfloor level and slightly below (about 3/8") the level of the hardwood flooring. Does the flange have to be raised to the level of the finished floor? If so, how?

Toilet flange installation [ 2 Answers ]

I am installing a new bathroom in the basement that was rough in by the plumber. I have a cast iron pipe for the toilet rough in. What do I use to cut the cast iron pipe to the correct height, and what is the correct height. I am also installing ceramic tile to the floor. Do I install the flange on...

Cast iron toilet flange the bolt holes will not hold how do we fix it and the flange [ 1 Answers ]

We have a cast iron flange and the bolt holes are not useable can we cut off the top and add a new plastic flange

View more questions Search