 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
What size wire should I use.
I have 200 amp Service on the pole approx 110 feet from my house, and I want to run a separate wire from the 200 amp breaker box on the pole,to the house for electric furnace only. What size wire should I use. I am planning on putting it in conduit and running under ground. I think this would be 100 amps from the pole to the furnace. Am I correct?What size wire and what size conduit.:) Thank You.
|
||||
|
||||
|
Your not making any sense. If you are at 200 Amp Service, you should have more than enough power to feed your furnace, without having to go outside of the main panel box.
First, look at the metal tag on the furnace and tell me what is the amperage required by the furnace. Then get back to us please. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
This is not really practical to try to deliver 120 volts at 150 feet and have the capacity for 400 amps. Assuming the maximum load of each 200 amp service to be 80% of full rating, would mean the calculations would be based on 320 amps, or 160 amps for each service entrance. Thanks for your...
I have a separate small living quarters that is a single room that is about 180 feet away from the main panel. It is going to get another little bed room a small kitchen and a bathroom also maybe a washer. The main panel is a 100 amp meter socket combo. What should I upsize the main panel to? ...
Back to Honduras, where the NEC don't apply.. I am installing a 150 amp service.. and it is about 100 ft from breaker panel to meter, and about 50 ft from meter to utility pole connection.. These people commonly use aluminum, and # 2 awg is the largest I can find.. Does anyone think this is...
What size wire should I use from the electrical meter to feed a 200 amp service panel in a 40' x 60" garage/barn? The run is about 10 feet long.
Mobile home requires 4 wire electrical service entrance wire. Distance is 160 foot from meter to breaker panel. 220V service. What size wire do I use? Can I use diff. size for neutral and ground?
View more questions Search
|
