 |
|
| Browse | Ask | Answer | Search | Join/Login |
|
|
||||
|
Goodman CLQ-30 won't turn off
I just installed a new Goodman CLQ-30 furnace evaporator and condenser. I have checked and rechecked all of the wiring. As soon as you turn on the 120 volts, the fan comes on and the condenser starts up. While the A/C is running, the diagnostic light is giving me 5 blinks. The manual says it is either a direct short to ground in the flame sensor circuit, lingering burner flame, or a slow closing gas valve. First off, the gas cock is turned off because I haven't installed the fule piping yet. Secondly, I checked the flame sensor with my meter and did not pick up a direct short. HELP!!
|
||||
|
||||
|
I would recheck you low voltage wiring from the thermost to the furnace and then to the outside condensing unit. The A/C should not come on unless there is a call from the thermostat for it to run.
You might have pinches or shorted a low voltage wire during the install. |
||||
| Question Tools | Search this Question |
Add your answer here.
Check out some similar questions!
What does A three blink code on a Goodman 80 plus gas furnace mean
I would like to hear some pros and cons on Goodman versus Rheem. I am currently using a 2 1/2 ton Goodman package unit heat pump to heat and cool my house here in central SC. But it is an older Seer 10 model and I would like to replace it with a Seer 13. The price of the Goodman and Rheem units...
I'm shopping for a new forced air furnace. The lowest price I have is for a high efficiency furnace made by Goodman. Never heard of this manufacturer. What is the quality rating for Goodman high efficiency furnaces? Thanks
My Goodman furnace will light and then go out. This will occur 3 times, then will quit running. The control board blinks 1 time and tells me to Check Gas flow, gas pressure, gas valve, and flame sensor. It seems to have gas going to the valve. Could this be a bad gas valve? Or a bad Flame...
View more questions Search
|
