Ask Experts Questions for FREE Help !
Ask
    stlman's Avatar
    stlman Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Nov 28, 2017, 06:56 PM
    My york diamond furnace lights blink 5 times. What's wrong
    York diamond blinks 5 times. Ignightor fails to glow now too.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #2

    Nov 28, 2017, 08:44 PM
    5 red is tripped rollout sensor. Look for a small red button near the burners. Make sure vent pipe is not obstructed.
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

York diamond 80 burners ignite shut down 3 times give 7 blink code [ 1 Answers ]

unit ignites 3 times shuts off with 7 blinking led code. Fame sensor replaced less then 1 year ago. cleaned flame sensor unit with pencil eraser (doesn't damage like steel wool or sandpaper) runs fine for two three days then back to error. no blockages in intake air/ vent air. had service tech out...

York diamond 80 red light on circuit board flashes 4 times. [ 2 Answers ]

York diamond 80 diagnostic code flashes 4 times [ 0 Answers ]

What started all this is my wife wanted heat. We turned on the thermostat, and the blower would not come on. The diagnostic light was flashing four times. Inside the door for the diagnostic codes it said auxillary/limit switch open. Couldn't find that so I just replaced the control board. Now...

Led flashes 4 times york diamond 80? [ 0 Answers ]

York Diamond 80 furnace Model # p3dnb16n06401a No heat - led flashes 4 times, problem start after I replaced 10u270v capacitor (motor was not running)

York diamond 90 furnace flashing 3 times need led status code to correct? [ 2 Answers ]

View more questions Search