Ask Experts Questions for FREE Help !
Ask
    abiscuit4u's Avatar
    abiscuit4u Posts: 1, Reputation: 1
    New Member
    		  
    #1

    Jul 20, 2017, 07:29 AM
    Can I disable all 4 safety switches on a husqvarna RZ 5424
    As stated above, there are 4 safety switches on this zero turn mower. Seat, left and right control arms, and the brake handle.
    donf's Avatar
    donf Posts: 5,679, Reputation: 582
    Printers & Electronics Expert
    		  
    #2

    Jul 20, 2017, 07:37 AM
    I will not address the technical aspects of this question. You really don't want to do that!!

    If for any reason you fall off that seat, those safety switches immediately kill the engine and stop the blades from turning. In turn, this keeps you from losing various parts of you body to spinning blades.

    DO NOT DO THIS!!
    talaniman's Avatar
    talaniman Posts: 54,325, Reputation: 10855
    Expert
    		  
    #3

    Jul 20, 2017, 07:50 AM
    Can explain why this is a good idea? I don't think it's wise at all.
    Stratmando's Avatar
    Stratmando Posts: 11,188, Reputation: 508
    Uber Member
    		  
    #4

    Jul 20, 2017, 07:53 AM
    Only time you would want to do that is for Troubleshooting, even then you have to be Extra Aware of the Dangers, and Hazzards. They are for Safety, They protect you or others, They could do a lot of Damage on a Body, or Someone Else's. Would be an easy Lawsuit if Someone else lost their Life or Limb(s) Good Luck. I understand some are a Pain or Inconvenient.
    ma0641's Avatar
    ma0641 Posts: 15,675, Reputation: 1012
    Uber Member
    		  
    #5

    Jul 20, 2017, 06:13 PM
    CAN you? Sure. Is it smart? NO. DBS!!
Not your question? Ask your question View similar questions
 

Question Tools Search this Question
Search this Question:

Advanced Search

Add your answer here.


Check out some similar questions!

Jumper safety switches [ 3 Answers ]

How do I jumper the brake satety and seat swith? Thanks

Safety switches on husqvarna lawn mower [ 0 Answers ]

I have a husqvarna iz4821 commercial zero turn mower that I can't get to start. I've replaced the battery (which was dead) and solenoid. I've gotten as far as getting the engine to crank, but not engage and turn over to start. Sometimes it won't even do that... I think it's a safety connection...

Safety switches are unhooked [ 2 Answers ]

All the safety switches have been bypassed and I need the wiring diagram to locate the main safety block.

L 110 Safety Switches [ 2 Answers ]

How can I disable the safety switch in my seat?

Disable a Motion Sensor on 3way Switches [ 2 Answers ]

I'm ready to "throw in the towel" on my outdoor floodlight, motion sensor operated by three-way switches. Most of the time the driveway just stays in the dark because the two different motion sensors I've tried are complicated to figure out on a 3-way switch. So I simply want to by-pass the...

View more questions Search